Lamp 165W LED plant 55xLED 420x212x62mm

The IEC 60320 standard defines an international set of non-locking appliance couplers for connecting power supply cords to electrical equipment up to 250 V.

The specification ensures electrical and mechanical interchangeability across a wide range of devices. Connectors are designated by even and odd numbers, where odd numbers (C7, C13, C19) refer to the female connector and even numbers (C8, C14, C20) to the male appliance inlet.

Widespread adoption of this standard has enabled global hardware manufacturing efficiency, allowing a single power supply unit to work worldwide by simply swapping the localized cord. In modern data center architectures, the shift toward C19/C20 standards is vital to handle the increased power density of high-performance servers.

Key Features

• Global standardization and compliance.
• Class I and Class II equipment support.
• High thermal tolerance variants available.

Standardized by the International Electrotechnical Commission.

1. Anode
2. Cathode

1. Lens/epoxy encapsulation (plastic capsule).
2. Metal contact (conducting wire).
3. Reflective cavity (reflective cup).
4. Semiconductor termination.
5. Anvil.
6. Post.
7. Anvil and post assembly replacing the filament.
8. Flat edge.

• For the ground wire, colored insulation tape will be used:
• Green.
• Green with a yellow line.
• For the neutral cable, blue insulating tape will be used.
• For the cable the phase isYou can use any other color:
• Any color different from neutral or earth.
• Black insulating tape.
• Brown insulating tape.
• Gray insulating tape.

• Duration of up to 50,000 hours, thanks to its dissipation system and voltControlled air.
• Fast on. The LED lights up much faster than a conventional light bulb.
• They do not emit almost heat, so they do not burn when touched.
• They contain no gas, no mercury, no pollutants.
• They consume 80% less than traditional light bulbs. Thanks to its continuous research, it is possible that this type of technology continues to evolve and reduce its consumption.
• LWhich emit, do not radiate ultraviolet or infrared rays.
• Low maintenance, since the LEDs do not melt, it only decreases its power. This dramatically lowers maintenance costs.
• Different shades, we can find different types of LEDs where we will find different shades of light, which can go from 2700K (yellow light) to 8000K (white light) without using filters.
• Sturdiness,If we compare with conventional light bulbs we find that LED technology withstands the vibrations much better. Ideal for what type of extreme installations.
• Emitting a direct light, the LED is characterized by being a directional light, so there is no loss of light.

1. Current by pulsations.
2. Direct current (DC).
3. Alternating current (AC).
4. Variable current.

1. The ground wire can be identified in several ways:
• Green cable.
• C cablegreen smell with a yellow line.
• Cable without insulation.
2. The neutral wire will be blue.
3. The phase cable can be identified in several ways:
• Any color different from neutral or earth.
• Black insulation.
• Brown isolate.
• Gray insulation.